Skip to main content
Jeparla
Favorites

Size guide: rings, bracelets and chains

In Azerbaijan a ring size is the ring's inner diameter in millimetres: a size 17 ring is 17 mm across inside. Sizes usually go in steps of 0.5. Measure around your finger and enter it in the helper below to see the nearest size.

Updated:

Ring size chart

The size number equals the inner diameter. The circumference is the diameter times π, rounded to one decimal.

Ring sizes: Azerbaijan size, inner diameter, inner circumference and ISO 8653 size
Size (AZ, CIS)Inner diameter, mmInner circumference, mmISO 8653 size
1515.047.147
15.515.548.749
1616.050.350
16.516.551.852
1717.053.453
17.517.555.055
1818.056.557
18.518.558.158
1919.059.760
19.519.561.361
2020.062.863
20.520.564.464
2121.066.066
21.521.567.568
2222.069.169
22.522.570.771
2323.072.372
23.523.573.874
2424.075.475

Source and calculation

Azerbaijan and CIS size: the inner diameter in millimetres, in steps of 0.5. This is the convention stores use; we did not find the text of a current standard we could cite.

ISO 8653:2016 (Jewellery — Ring-sizes — Definition, measurement and designation) designates a ring size by its inner circumference in mm; most of Europe uses this system. In the chart the ISO size is the circumference rounded to a whole millimetre.

US sizes are not shown: we found no current published standard for that conversion, and we will not invent one.

Every number comes from exact decimal arithmetic, with halves rounded up.

Ring size helper

Enter the number you measured. Measure around the finger with a thread or a paper strip, or measure across an existing ring.

What did you measure?

For example 53.5. A dot or a comma, at most two decimals.

The nearest size appears here once you enter a number.

Exactly half-way between two sizes, the helper picks the larger one.

How to find your ring size at home

With a ring you already have

  1. Pick a thin, round ring that fits the same finger comfortably.
  2. Lay it on a ruler marked in millimetres.
  3. Measure across the widest part, from inside edge to inside edge, without the metal.
  4. That number in millimetres is your size. In the helper, choose "Inside diameter of a ring".

With a thread or a paper strip

  1. Take a thread that does not stretch, or a paper strip about 5 mm wide.
  2. Wrap it around the base of the finger, snug but not tight.
  3. Mark where the ends meet with a pen.
  4. Unwrap it and measure up to the mark with a ruler, in millimetres: that is the circumference.
  5. Enter the number in the helper and check that the ring will pass over the knuckle.
Inner diameter and inner circumference of a ringThe straight line across the inside of the ring is the inner diameter; the circle along the inside edge is the inner circumference.diametercircumference
Inner diameter and inner circumference of a ring

For a more accurate result

  • Measure at the end of the day in a warm room: fingers are thinner in the cold and fuller in the heat.
  • Measure two or three times and compare.
  • If the knuckle is wider than the base of the finger, the ring has to pass over it: measure both.
  • A wide band (about 6 mm or more) sits tighter; ask the store whether you need half a size up.

Bracelet length

Measure the wrist just above the wrist bone with a thread or a strip. For a chain bracelet to sit comfortably, 1 to 2 cm is usually added to the wrist measurement.

Bracelet lengths and who they usually fit
LengthUsually
15–16 cmSlim wrist, sits close
17–18 cmA frequent length for women's bracelets
19–20 cmA looser women's fit or a smaller men's bracelet
21–22 cmA frequent length for men's bracelets

A rigid bangle that does not open has to pass over the hand: touch the thumb to the little finger, measure around the widest part of the hand, and ask the store for the bangle's inner size.

These lengths are general guidance, not a standard; stores and designs differ.

Chain length

A chain is measured laid flat, clasp included. Where it sits depends on the neck and on any pendant.

Chain lengths and where they usually sit
LengthUsually sits
40 cmClose to the base of the neck
45 cmAt the collarbone; a frequent choice for a pendant
50 cmJust below the collarbone
55 cmAt the neckline; frequent for men's chains
60 cmBelow the neckline, over clothing
70 cm and longerA long chain over clothing; can be worn doubled

The simplest way: lay a chain you already own flat, measure it, and choose shorter or longer from how you like it.

Sources

  • ISO 8653:2016, Jewellery — Ring-sizes — Definition, measurement and designation (International Organization for Standardization).
  • Azerbaijan and CIS size numbers (inner diameter, mm): the convention used by stores.
  • Bracelet and chain lengths: general guidance, not a standard.